Healthrider H120 HMTL39906.1 - Manual (Page 8)

8
7. Identify the Right Handrail (72), which has a large hole
in the left side. Feed the Upright Wire (42) into the hole
in the bottom of the Right Handrail and out of the large
hole in the side. Note: It may be helpful to use
needlenose pliers to pull the colored wire and Upright
Wire out of the hole.
Then, attach the Right Handrail (72) to the Right Upright
(90) with two Handrail Bolts (37) and two 5/16" Star
Washers (95).
Attach the Left Handrail (71) to the Left Upright (7) in
the same way. Note: There is not a wire on the left side.
Remove the colored tie from the Upright Wire (42).
Large
Hole
72
95
42
37
37
95
71
90
7
7
5. Attach two Round Base Pads (57) and an Extension
Leg Pad (61) to the Upright Base (69) and Extension
Leg (63) with four 1" Tek Screws (39) as shown.
63
61
39
39
39
57
5
6. Attach a Wheel (66) to the Upright Base (69) with a
Wheel Bolt (64) and a Nut (13) as shown. Do not over-
tighten the Wheel Bolt; the Wheel should turn freely.
With the help of a second person, carefully tip the tread-
mill up so the Round Base Pads (57) are on the floor.
69
13
66
64
6
57
69