5700 act wood stove, Brick replacement instructions – Hearth and Home Technologies 820-0721 User Manual

Page 23

Advertising
background image

Page 23

September 1, 2008

5700 ACT Wood Stove

R

250-7090e

BRICk REPLACEMENT INSTRUCTIONS

Use Part 832-0550 when ordering individual brick

provide brick dimension or copy this page and mark

the brick you need and take it to your authorized

dealer.

3

3

3

3

1

1

1

1

1

1

1

1

1

1

1

1

1

1

1

1

1

1

7

4

4

2

2

5

5

6

1. After the coals have completely cooled, remove all old

brick and ash from unit and vacuum out firebox.

2. remove new brick set from box and lay out to diagram

shown above.

3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks.

Slide top of bricks under clip on back of firebox wall

and push bottom of brick back.

5. Install side bricks. Slide top of brick under clips on

side of firebox and push the bottom of the brick until

it is flush with the side of the unit.

Nbr brick Size

Qty in Set

1

9 x 4.5 x 1.25”

18

2

9 x 3.75 x 1.25”

2

3

9 x 2.0 x 1.25”

4

4

7 x 3.25 x 1.25”

2

5

9 x 4.5 x 1.25” with hole

2

6

6.5” x 2.0” x 1.25”

1

7

4.5” x 2.0” x 1.25

1

GLASS REPLACEMENT

Replace with 5mm ceramic glass only

1. ensure that the fire is out and the stove is cool to the touch.
2. Protect a table or counter top with padding or towels.
3. remove the door with the broken glass by lifting the door up and off of the hinges.
4. Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, on

a soft surface.

5. remove the screws from each glass retainer and remove the glass. (If screws are difficult to remove, soak with

penetrating oil first).

6. Center the glass with edges evenly overlapping the opening in the door, (i.e. same space top and bottom, left

and right sides).

7. replace the glass retainers. be careful not to cross thread the screws.
8. Tighten each retainer just a few turns until each is secured. Check again for centering of glass in door frame.

Then continue to tighten each retainer alternately, a few turns at a time, until the glass is secured. DO NOT

OVerTIgHTeN.

9. replace the door on the appliance.

Advertising