HP 2600 Series - Manual (Page 272)

10-4
Traffic/Security Filters (ProCurve Series 2600/2600-PWR and 2800 Switches)
Using Source-Port Filters
Using Source-Port Filters
This feature is available only on the Series 2600, 2600-PWR, and 2800
switches.
Operating Rules for Source-Port Filters
■ You can configure one source-port filter for each physical port or port
trunk on the switch.
■ Each source-port filter you configure is composed of:
• One source port or port trunk ( trk1, trk2, ...trk6)
• A set of destination ports and/or port trunks that includes all LAN
ports and port trunks on the switch
• An action for each destination port or port trunk
When you create a source-port filter, the switch automatically sets the
filter to forward traffic from the designated source to all destinations for
which you do not specifically configure a "drop" action. Thus, it is not
necessary to configure a source-port filter for traffic you want the switch
to forward unless the filter was previously configured to drop the desired
traffic.