HP 2600 Series - Manual (Page 65)

3-21
Web and MAC Authentication for the Series 2600/2600-PWR and 2800 Switches
Configuring Web Authentication
Syntax: aaa port-access web-based [e] < port-list > [redirect-url <url>]
no aaa port-access web-based [e] < port-list > [redirect-url]
Specifies the URL that a user is redirected to after a
successful login. Any valid, fully-formed URL may be
used, for example, http://welcome-server/welcome.htm
or http://192.22.17.5. ProCurve recommends that you
provide a redirect URL when using Web Authentica-
tion.
Use the no form of the command to remove a specified
redirect URL.
(Default: There is no default URL. Browser behavior
for authenticated clients may not be acceptable.)
Syntax: aaa port-access web-based [e] < port-list > [server-timeout <1 - 300>]
Specifies the period, in seconds, the switch waits for a
server response to an authentication request. Depend-
ing on the current
max-requests value, the switch sends
a new attempt or ends the authentication session.
(Default: 30 seconds)
Syntax: [no] aaa port-access web-based [e] < port-list > [ssl-login]]
Enables or disables SSL login (https on port 443). SSL
must be enabled on the switch.
If SSL login is enabled, a user is redirected to a secure
page, where they enter their username and password.
If SSL login is
disabled, a user is not redirected to a
secure page to enter their credentials.
Use the no form of the command to disable SSL login.
(Default: disabled)
Syntax: aaa port-access web-based [e] < port-list > [unauth-vid <vid>]
no aaa port-access web-based [e] < port-list > [unauth-vid]
Specifies the VLAN to use for a client that fails authen-
tication. If
unauth-vid is 0, no VLAN changes occur.
Use the no form of the command to set the unauth-vid to 0.
(Default: 0)