Automatic transmission fluid – HONDA 2009 CR-V User Manual

Page 291

Advertising
background image

CONTINUED

Check the fluid level with the engine
at normal operating temperature.

Park the vehicle on level ground.
Start the engine, let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) before
doing step 2.

Remove the dipstick and check
the fluid level. It should be
between the upper and lower
marks.

If the level is below the lower
mark, add fluid into the dipstick
hole to bring it to the level
between the upper and lower
marks.

Insert the dipstick all the way into
the transmission securely as
shown in the illustration.

Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.

Pour the fluid slowly and carefully
so you do not spill any. Clean up
any spill immediately; it could
damage components in the engine
compartment.

Always use Honda Genuine
ATF-Z1 (automatic transmission
fluid).

1.

2.

3.

5.

4.

Automatic Transmission Fluid

Ma

int
e

na
nce

287

DIPSTICK

UPPER
MARK
LOWER
MARK

2009 CR- V

Table Of Contents

Main Menu

Advertising
This manual is related to the following products: