Hypertec PCI 10/100 TX - Manual (Page 10)

The setup program can view current configuration and run
diagnostics on the HyperNet PCI 10/100 series Adapters. This
testing includes three separate procedures:
•
View Current Configuration
•
Setup New Configuration
•
Run diagnostics Menu
Adapter cannot connect to the network
Make sure that the cable is installed properly. The network cable
must be securely attached to all connections. If the cable is
attached, but the problem persists, try using a different cable.
Note: If you're operating at 100 Mbps, you must use UTP
Category 5 wiring.
If you're directly connecting two workstations (no hub), use a
cross-over cable.
•
Check the LED lights on the adapter. These lights help to
indicate if there's any problem with the connector, cables, or
hub.
•
The Link LED light is ON when the adapter receives a Link
pulse from the Ethernet Hub or card.
•
If the Link LED light is off, it may be caused by a bad
connector, bad cable, or any problem with the hub.
•
The ACT LED light is flashing when there's transmitting or
receiving activity on the network.