Hypertec PCI 10/100 TX - Manual (Page 6)

•
Turn OFF the power to the computer to prevent any
accidental damage.
•
Remove your computer's cover (refer to your computer
owner's manual).
•
Select an available PCI expansion slot which supports Bus
Master mode, and remove slot cover. Make a note of the slot
number (if one is printed on the motherboard, next to this
slot).
•
Carefully install the adapter by firmly pressing the card into
the slot which you have chosen, and applying even pressure
until the adapter is completely seated in the slot.
•
Fasten the retaining bracket with the screw on the slot cover.
Make sure the adapter is properly aligned.
•
Replace the system box cover and fasten it.
Connecting to the Network
This section describes how to connect 10Mbps or 100Mbps
network cables to the HyperNet PCI 10/100 series adapter. The
backplate of the HyperNet PCI 10/100 series adapter contains
one RJ-45 connector. This adapter can use auto-negotiation to
automatically determine line operating conditions, such as
10Base-T, 100Base-TX, or a corresponding Full-Duplex mode
based on the type of HUB to which it is connected.
For 10Base-T Ethernet networks:
Use Category 3, 4, or 5 UTP cabling.