haier GDZ22-1 - Manual (Page 21)

20
English
4-Wire Cord Connections
1. Remove the screws securing the terminal block access cover
and the strain relief mounting bracket located on the back
of the dryer upper corner.
2. Install a U.L. approved strain relief into the power cord entry hole
of the mounting bracket. Finger tighten the nut only at this time.
3. Remove the green neutral ground wire from the green ground
screw located above the terminal block.
green
ground
screw
green neutral
ground wire
green power cord
ground wire silver terminal
terminal block
tighten nut to
these threads
black
white
nut
strain relief
mounting bracket
power cord
Typical
Conductor
Receptacle
Typical
4 Conductor
Cord
black 240V
white neutral
red 240V
green ground
30 AMP NEMA 14-30 TYPE SRDT OR ST
red
GDZ22-1 manual 10/22/01 11:45 AM Page 21