Hitachi CP-X205 - Manual (Page 99)


Projector Management using SNMP
The SNMP (Simple Network Management Protocol) enables to manage the
projector information, which is a failure or warning status, from the computer on
the network. The SNMP management software will be required on the computer
to use this function.
• It is recommended that SNMP functions be carried out by a network
administrator.
• SNMP management software must be installed on the computer to monitor
the projector via SNMP.
NOTE
61036HWWLQJV
&RQ¿JXUHWKHIROORZLQJLWHPVYLDDZHEEURZVHUWRXVH6103
Example: If the IP address of the projector is set to 192.168.1.10:
‡$1HWZRUN5HVWDUWLVUHTXLUHGDIWHUWKHSNMP PortFRQ¿JXUDWLRQ
settings have been changed. Click [Network Restart] DQGFRQ¿JXUHWKH
following items.
NOTE
 &OLFN[Security Settings] on the main menu.
 &OLFN[SNMP] and set the Community Name on the screen that is displayed.
‡$1HWZRUN5HVWDUWLVUHTXLUHGDIWHUWKHCommunity Name has been
changed. Click [Network Restart] DQGFRQ¿JXUHWKHIROORZLQJLWHPV
NOTE
 &RQ¿JXUHWKHVHWWLQJVIRU7UDSWUDQVPLVVLRQRI)DLOXUHV:DUQLQJV&OLFN
[Alert Settings] on the main menu and select the Failure/Warning item to be
FRQ¿JXUHG
8) Click the [Enable] check box to send out the SNMP trap for Failures/Warnings.
Clear the [Enable] check box when SNMP trap transmission is not required.
 &OLFNWKH[Apply] button to save the settings.
1) Enter "http://192.168.1.10/" into the address bar of the web browser.
 (QWHUWKH$GPLQLVWUDWRU,'DQGSDVVZRUGDQGFOLFN[Logon].
 &OLFN[Port Settings] on the main menu.
4) Click the [Enable] check box to open the SNMP Port.
Set the IP address to send the SNMP trap to when a Failure/Warning occurs.
3URMHFWRU0DQDJHPHQWXVLQJ6103