HP 4 FAMILY - Manual (Page 107)

AppleTalk
Configuration
Command
As discussed in the HP LaserJet 4 section of this chapter,
the AppleTalk Configuration command allows a user to
send PCL jobs to the printer over AppleTalk. In addition to
the key values previously discussed (RENAME, TYPE, and
JOB), the HP Color LaserJet printer also supports the
ZONE key value as follows.
ZONE
ZONE changes the zone field of the printer’s AppleTalk
Network Identifier (Name Binding Protocol type field).
?&b#WZONE<sp>zonename
Valid characters for the zone name include 0-255 except for
characters $00, “@” ($40), “:” ($3A), “*” ($2A), “=” ($3D),
$C5, and ($FF). The zone name must contain at least one
character, and only the first 31 characters are used. If the
zone is invalid, then the printer’s zone is not changed. Zone
changes only occur after the present job has completed.
Feature Status Comments
PC (Pen Color—HP-GL/2) New Changes the pen color in a palette created by the IN or CID
command (?*v#W).
Push/Pop Palette New Pushes or pops the palette from the palette stack.
Raster Scaling New/Modified Several commands are added for raster scaling: Destination
Raster Width (?*t#H), Destination Raster Height (?*t#V);
also, two parameters are added to the Start Raster Graphics
command to initiate scaling (?*r2A and ?*r3A). (See the PCL
5 Color Technical Reference Manual for more information.)
Render Algorithm New Selects the algorithm to be used for rendering page marking
entities on a given page.
Select Palette by ID New Activates a palette with the specified ID number.
Set Viewing Illuminant New Specifies the relative white point used in the determination of
a viewing illuminant condition.
Simple Color New Specifies an unmodifiable fixed-size palette.
Transfer Raster Graphics (by
plane) New Provides a means to send raster data by color plane. This
command sends a plane of raster data to the printer and
advances to the next plane.
Table 2-14. PCL Feature Additions for HP Color LaserJet Printer (continued)
Printer-Specific Differences 2-71