HP 4 FAMILY - Manual (Page 114)

Output Bin Command This command selects the destination bin into which the
print job is output when printed.
?&l#G
# = 0 - Automatic selection
1 - Selects bin #1 (printer top/face-down bin)
2 - Selects bin #2 (printer left/face-up bin; this
bin not available when the High Capacity
Output (HCO) is attached)
3 - Selects bin #3 (HCO face up bin)
4 - Selects bin #4 (HCO #1 face down bin)
5 - Selects bin #5 (HCO #2 face down bin)
6 - Selects bin #6 (HCO #3 face down bin)
7 - Selects bin #7 (HCO #4 face down bin)
8 - Selects bin #8 (HCO #5 face down bin)
9 - Selects bin #9 (HCO #6 face down bin)
10 - Selects bin #10 (HCO #7 face down bin)
11 - Selects bin #11 (HCO #8 face down bin)
Default = 0
Range = 0 to 11
Note The Output Bin command is not recommended. Instead, it
is preferred that the PJL OUTBIN command be used to set
the default media destination.
2-78 Printer-Specific Differences