Before using, Before using installation and adjustment, Adjust the installation position – haier HWM70-98 User Manual

Page 5: Install the inner cover components, Install the bottom plate

Advertising
background image

Inner cover shaft

Outer tub cover
shaft groove

Outer tub cover

Inner cover

Install the bottom plate

After opening the package, please lean
the washing machine gently down on
soft items (like towel cloth, blanket, etc.).
Install the bottom plate to the bottom
of the machine with eight screws by a
c r o s s s c r e w d r i v e r, t h e n l i f t t h e
machine up gently. See to the figure:

Adjust the Installation position

The largest allowed slope of the shank base of the machine is 2

. The slanting or rough ground will result in

unstable running or stoppage of the machine. Please adjust it with following methods:

Confirm it's horizontal

Hang the plumb to confirm it's

horizontal

Adjust the adjustable foot

(1) To twist the adjustable foot at the right front of
the cabinet (front the sight of front), please first
lift up the side of the foot slightly, loosen the
adjustable nut, and twist the foot.

(2) Fasten the nut after adjustment.

Loosen

Fasten

High

Low

adjustable nut

adjustable foot

Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.

Before Using

Before Using

Installation and adjustment

Install the inner cover components

1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming
the inner cover shaft to the installation hole of the corresponding
outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of

I side into the correspon

-ding outer tub cover shaft groove, then push the another inner
cover shaft into the corresponding outer tub cover shaft groove.
Please install to designated position to guarantee there are no
dropping or abnormal sound in opening and closing of the inner
cover, and the operation shall be smooth. Do not dismount the
inner cover component after washing.

Soft items

Back

Screw

Front

Bottom plate

Advertising