Hitachi VT-FX602S - Manual (Page 24)

PRESET FOR USE - 24 -
button or directly pressing number buttons on the remote control.
Note for using number buttons:
• When selecting cable channels which are higher than 100, press 100/ENT
button first, then press the last two digits. (To select channel 125, first press
"100/ENT" button then press "2" and "5").
• You must precede single-digit channel numbers with a zero (02, 03, 04 and so
on).
TO DELETE PRESET CHANNEL
The channels you no longer receive or seldom watch can be deleted from
the memory. (Of course, you can add the deleted channel into the memory
again.)
NOTE: You must use the remote control for this procedure.
Make sure...
• VCR power must be turned on.
• Turn on the TV and set the TV channel to the same video output channel
as located on the back of the VCR. (CH 3 or 4)
• Press VCR/TV button on the remote control so that "VCR" appears on
the display.
1 Select the main menu
Press MENU button. The main menu appears on the TV screen.
MENU
TIMER PROGRAMMING
VCR SET UP
INITIALIZE
2 Select "INITIALIZE"
Press CH/SET
or button repeatedly to point to "INITIALIZE".
Then, press SELECT button.
MENU
TIMER
PROGRAMMING
VCR SET UP