Honeywell HCM-6009 User Manual

Page 12

Advertising
background image

12

12

Troubleshooting

PROBLEM

POSSIBLE CAUSE

CORRECTIVE ACTION

The unit is on (the lights are
illuminated) but I don't see
any moisture

Cool Moisture humidifiers produce
invisible mist. You will not see the
moisture but you will feel cool air coming
from the unit.

Monitor the water level in your tank/base.
If you notice a decrease in the water tank
over a 24hr. Period your unit is running
normally.

Unit is out of water

Refill and reinstall water tank

Humidity level is set too low

Reset humidity to a higher level. If you
have a manual humidistat/knob (Models
HCM-6011i/HCM-6011WW) turn the knob
clockwise to the end.

Unit is not on level surface

Place the unit on a firm, flat, and level
surface

There is too much moisture inside the
unit

Turn off the power and completely dry out
the unit

Filter has not absorbed water

Wait 15 minutes so the filter gets fully
absorbed or soak your filter in water. (Do
not squeeze or wring out the filter) See
filling instructions for more information.

Mineral buildup in water tray

See Cleaning instructions. Regular
cleaning is recommended to keep the unit
functioning properly.

Filter needs to be replaced

If your filter is discolored, clogged or torn
replace your filter (Model HC-14). Visit the
retailer where you purchased your unit or
call 1-800-477-0457.

The unit is not running; no
lights are illuminated

Not plugged in properly

Check the polarized plug to ensure it is
fully inserted in the wall

Airflow obstruction

Check airflow. Are there any obstructions
preventing airflow?

Unit is off due to timer

Press Power button (HCM-6012i only)

Power unit is not installed properly

Reinstall the power unit

Humidity level was set but
unit does not start

Humidity level is set too low

Reset humidity to a higher level. If you
have a manual humidistat/knob (Models
HCM-6011i/HCM-6011WW) turn the knob
clockwise to the end.

Humidity level was set but
the unit does not shut off

Humidity level is set too high

Reset humidity to a lower level.

QuietCare_Console_OM_Rev1.qx 8/25/06 1:32 PM Page 12

Advertising