HONDA 2010 Civic Sedan - Manual (Page 306)

If you replaced a headlight bulb on
the driver’s side, reinstall the
engine coolant reserve tank.
To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
left.
Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
Remove the bulb by turning it one-
quarter turn counterclockwise.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
Turn on the headlights to test the
new bulb.
Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
2.
3.
2.
4.
5.
6.
7.
1.
CONTINUED
Lights
Low Beam Headlight
Ma
int
e
na
nce
303
TAB
HOLDING CLIP BULB
09/07/02 17:19:25 31SNA640_308