6 operation of the controller – Honeywell ELECTRONIC REFRIGERATION CONTROL PCR-300 User Manual

Page 9

Advertising
background image

Note: It takes approximately 24 hours for the battery to achieve its

full back-up capacity.
The battery will provide cover for a power failure of approximately
1 month.

6 Operation of the controller

Front view of controller:

6.1 Switching on the operating voltage
The controller is started by means of a control switch provided by the
customer.
The first time the controller is started, pre-programmed setting values
are used which at later point can be adapted for individual
requirements.
If alarm “AL 2” (temperature in refrigerated chamber too high
or too low) is displayed when the controller is switched on, this
can be cleared by pressing the

key.

6.2 Display
During normal operation the current cold store temperature is
displayed. It is measured with cold store sensor T1.
In the event of an alarm, the most recent alarm message (e.g. AL1)
and the cold store temperature are displayed alternately.

9

Advertising
This manual is related to the following products: