Horizon Fitness LS 645E - Manual (Page 5)

BEFORE
YOU
BEGIN

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y

INTRODUCTION
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
IMPORT
ANT
PRECAUTIONS
A) Open HARDWARE BAG FOR STEP 2.
B) Carefully pull the CONSOLE CABLES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
C) Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT
WASHERS (C).
D) Attach the TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.
E) Slide CONSOLE MAST BOOT down to seal the console mast hole.
ASSEMBLY STEP 
CONSOLE MAST
CONSOLE MAST BOOT
MAIN FRAME
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
TOP FRONT COVER
TOP BACK COVER
CONSOLE MAST BOOT
CONSOLE WIRES
#0-5
"

NN
2UZ
 413*/(
8"4)&3
#

NN
2UZ
 '-"5
8"4)&3
$

NN
2UZ

HARDWARE BAG FOR STEP 2 CONTENTS :
ASSEMBLY STEP 2
PEDAL ARM
PEDAL ARM TUBE
TEFLON WASHERS (F)
BOLT (H)
FLAT WASHER (G)
LOWER LINK ARM
LINK ARM BRACKET
SPACER (E)
A ) Open HARDWARE BAG FOR STEP 3.
B) Align the bracket on the LEFT LOWER LINK ARM with the tube on the LEFT PEDAL ARM.
C) Slide the SPACER (E) through the LINK ARM BRACKET and the PEDAL ARM so it can’t rotate.
D) Insert 2 TEFLON WASHERS (F) between the PEDAL ARM and the LINK ARM BRACKET.
E) Secure the joint with a FLAT WASHER (G) and BOLT (H).
F) Repeat on the other side.
BOLT (H)
15 mm
Qty: 2
SPACER (E)
70 mm axis
Qty: 2
FLAT WASHER (G)
35 mm
Qty: 2
SPLIT TEFLON WASHER (F)
30 mm
Qty: 4
HARDWARE BAG FOR STEP  CONTENTS :
LS_645E_Rev.1.7.indd 8-9 6/25/08 10:43:26 AM