Assembly step 4 assembly step 5 – Horizon Fitness LS 645E User Manual
Page 6
BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
11
INTRODUCTION
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
IMPORT
ANT
PRECAUTIONS
ASSEMBLY STEP 4
ASSEMBLY STEP 5
A) Open
HARDWARE BAG FOR STEP 5 (contents on next page).
B) Slide
SPACER (I) into LOWER LINK ARM.
C)
Place TEFLON WASHERS (J) on either side of SPACER (I). While holding TEFLON WASHERS (J) slide LOWER
LINK ARM into bottom end of LOWER HANDLEBAR.
D) Insert
BOLT (K) into LOWER HANDLEBAR and secure using NUT (L).
E) Attach the
OUTSIDE ELBOW COVER to elbow joint using 1 SCREW (M).
F) Snap the
INSIDE ELBOW COVER onto the OUTSIDE ELBOW COVER.
Note the position of the snap tabs before snapping into position.
G) Repeat on other side.
INSIDE
ELBOW COVER
OUTSIDE
ELBOW COVER
SCREW (M)
LOWER HANDLEBAR
GUIDE RAIL
TEFLON WASHERS (J)
LOWER HANDLEBAR
NUT (L)
BOLT (K)
LOWER LINK ARM
SPACER (I)
LOWER LINK ARM
SPACER
TEFLON WASHERS
LOWER
HANDLEBAR
LOWER HANDLEBAR
CONSOLE MAST
PRE-ATTACHED
BOLT & WASHER
UPPER HANDLEBAR
PRE-ATTACHED
SET SCREWS
NOTCH
TAB
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove
PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B) Slide
LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.
c) Slide
UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are
joined together completely. Secure
UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET
SCREWS.
C) Snap the front and back
HANDLEBAR COVERS together onto the UPPER HANDLE BARS.
Note the position of the snap tabs on the covers before snapping into position.
D) Repeat on other side.
E) Attach
WATER BOTTLE CAGE to CONSOLE MAST using PRE ATTACHED SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
FRONT
HANDLEBAR
COVER
BACK
HANDLEBAR
COVER
UPPER
HANDLEBAR
LOWER
HANDLEBAR
WATER BOTTLE CAGE
PRE-ATTACHED
SCREWS
LS_645E_Rev.1.7.indd 10-11
6/25/08 10:43:28 AM