Heat & Glo Fireplace HEAT & GLO ESCAPE-I35-C User Manual
Page 36
Heat & Glo • Escape-I35-C, Escape-I30-C • 2201-901 Rev. K • 1/13
36
2201-935E
Figure 8. Place Log #5
Figure 9. Place Log #6
GLASS ROCK (2201-853): Once Log #3 and Log #4 are installed, fi ll each light tray with the glass rock. See Figure 7.
WARNING! Risk of Explosion! DO NOT place glass rock on the burner surface. DO NOT place glass rock directly over
burner ports. Improperly placed glass rock interferes with proper burner operation.
LOG #5 (SRV2201-703): SEE FIGURE 2 FOR ADDITIONAL REFERENCES. Place the thick end of Log #5 on the fl at
spot of Log #1. Locate the groove on the thin end of the log. Mate the groove with the grate bar as shown above. Swing
the front end of the log to the right, until it contacts the second grate tine from the right.
PLACE LOG ON FLAT SPOT
PLACE LOG ON FLAT SPOT
FLAT SPOT
FLAT SPOT
FOR LOG #6
FOR LOG #6
Log #6 (SRV2201-706): See Figures 2 and 4 for additional references. Place the thick end of the log on the fl at spot of Log
#2. Place the thin end of the Log #6 on the fl at spot of Log #5 as shown in Figure 8.
GROOVE MATES
GROOVE MATES
WITH GRATE BAR
WITH GRATE BAR
5
6
Figure 7. Glass Rock in Place
GLASS ROCK
GLASS ROCK
LOG TOUCHES GRATE TINE
LOG TOUCHES GRATE TINE