Assembly step – Horizon Fitness CLUB S400 User Manual
Page 7
12
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
&
MAINTENANCE
LIMITED
W
ARRANTY
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP
FLAT WASHER (J)
Qty: 8
NYLON NUT (K)
Qty: 4
BUMPER
Qty: 2
BOLT (I)
Qty: 4
HARDWARE BAG CONTENTS :
Open HARDWARE BAG .
Remove nylon nut and threaded
screw from end of CABLE A.
Insert cable end into LAT BAR
ASSEMBLY BRACKET pulley as
shown in diagram.
NOTE: After passing through
second pulley bracket, DUAL
FLOATING PULLEY BRACKET
must be installed.
Re-install threaded screw and
nylon nut before threading
cable into TOP WEIGHT PLATE.
NOTE: Always maintain at least
½˝ of weight cable screw in
TOP WEIGHT PLATE for saftey.
Hook LAT BAR on to cable using
the HOOK and rest in craddle.
A
B
C
D
E
ASSEMBLY STEP
CABLE A
Qty: 1
HARDWARE BAG CONTENTS :
CABLE A
LAT BAR
RUBBER STOP
BALL
NYLON NUT (C)
FLAT WASHER (B)
DUAL FLOATING
PULLEY BRACKET
LAT BAR / WEIGHT
CABLE SCREW AND NUT
TOP WEIGHT
THREAD
HOOK
CLEVIS
FLAT WASHER (B)
SCREW (E)
Open HARDWARE BAG .
Insert each GUIDE ROD into the BASE FRAME as shown in diagram.
NOTE: Ensure that holes in GUIDE RODS are located at the top.
Install rubber BUMPER onto each GUIDE ROD.
Install each WEIGHT PLATE onto GUIDE RODS
NOTE: Ensure that each WEIGHT PLATE’s selector pin slot faces downward.
Insert each GUIDE ROD into the corresponding hole in the UPPER PULLEY ASSEMBLY.
Secure GUIDE RODS in UPPER PULLEY ASSEMBLY using 2 BOLTS (I), 4 FLAT WASHERS (j)
and 2 NYLON NUTS (K).
NOTE: Ensure that each bolt is inserted through the hole at the top of the GUIDE ROD.
Install 2 BOLTS (I), 4 FLAT WASHERS (j) and 2 NYLON NUTS (K) into the BASE FRAME as
shown in diagram.
Tighten all hardware.
A
B
C
D
E
F
G
H
BUMPER
GUIDE ROD
WEIGHT PLATE
TOP WEIGHT
BAYONET
SELECTOR PIN
NYLON NUT (K)
FLAT WASHER (J)
FLAT WASHER (J)
SCREW (I)
FLAT WASHER (J)
SCREW (I)
S400_US_1.1.indd 12-13
8/31/07 10:10:35 AM