Hoshizaki F043-809 KMD-410MWH - Manual (Page 55)

51
5) Refit the removed parts in the reverse order of the removal procedure.
Note: After replacing the components inside the control box, connect and tie the wires
properly in their correct position. Especially make sure that the harness does not
press the push buttons on the control board.
Control Box Cover
Control Box
Screw
Screws
Controller Board
Control Switch
Service Switch
Fuse
Fuse Holder
Starter
Transformer
Capacitor for Pump Motor
Magnetic Contactor
Push Buttons
Run Capacitor
Start Capacitor
Noise Suppression Capacitor