Horizon Fitness PREMIER T1201 - Manual (Page 6)

10
INTR
ODUC
TION
IMPOR
TANT
PRE
CA
UTIONS
BEF
ORE
YOU
BE
GIN
TREADMILL OPER
ATION
LIMITED
W
ARR
ANTY
TR
OUBLE
SHOO
TING
&
MAINTENANCE
CONDITIONING
GUIDELINE
S
AS
SEMBL
Y
BEF
ORE
YOU
BE
GIN
AS
SEMBL
Y
11
INTR
ODUC
TION
IMPOR
TANT
PRE
CA
UTIONS
TREADMILL OPER
ATION
CONDITIONING GUIDELINE
S
TR
OUBLE
SHOO
TING
&
MAINTENANCE
LIMITED
W
ARR
ANTY
ASSEMBLY STEP  ASSEMBLY STEP 
RIGHT HANDLEBAR
CONSOLE MASTS
BOLTS (A)
FLAT WASHERS (B)
ARC WASHERS (D)
SPRING WASHERS (C)
SPRING WASHERS (C)
BOLTS (A)
CONSOLE CABLE
Open HARDWARE BAG .
With the running deck in the
lowered position, place the
RIGHT HANDLEBAR on top of
the RIGHT CONSOLE MAST.
Carefully route the CONSOLE
CABLE through the bottom
of the handlebar and out the
CABLE HOLE as shown in
second drawing below. The
PULSE CABLE and POWER
CABLE should be pulled out of
the hole as well.
NOTE: Do not pinch the
CONSOLE CABLE when placing
right handlebar on top of the
RIGHT CONSOLE MAST.
To assemble the RIGHT
HANDLEBAR to the RIGHT
CONSOLE MAST, insert
2 BOLTS (A), 2 SPRING
WASHERS (C) and 2 FLAT
WASHERS (B) in the inside
of the mast and 1 BOLT (A), 1
SPRING WASHER (C) and 1 ARC
WASHER (D) in the rear of the
mast as shown.
Repeat on other side.
NOTE: Only the pulse cable
will need to be routed through
the cable hole on the left
handlebar.
A
B
C
D
BOLT (A)
20 mm
Qty: 6 FLAT WASHER (B)
8 mm
Qty: 4 SPRING WASHER (C)
8 mm
Qty: 6 ARC WASHER (D)
8 mm
Qty: 2
HARDWARE BAG  CONTENTS:
CABLE HOLE
CONSOLE CABLE
RIGHT CONSOLE MAST
RIGHT HANDLEBAR
PULSE CABLE
POWER CABLE
CONSOLE CABLE
CONSOLE
CUP HOLDER
SCREW (F)
SCREWS (E)
Open HARDWARE BAG .
Attache CUP HOLDERS to CONSOLE by inserting 4 SCREWS (E) and 2 SCREWS (F).
A
B
SCREW (E)
15 mm
Qty: 4 SCREW (F)
30 mm
Qty: 2
HARDWARE BAG  CONTENTS:
NOTE: Carefully align holes
when assembling handlebars to
console mast, making sure to
not press down on handlebars.
NOTE: Assembly of cup holders may be easier if console is flipped upside down before inserting
screws. Be careful not to overtighten screws.
NOTE: Do not completely
tighten any screws or bolts
until step 6 is complete!
T1201_Rev.1.7.indd 10-11 7/31/08 4:52:39 PM