HTC Touch HS S00 - Manual (Page 13)

 Getting Started Getting Started 
1.3 Starting Up
After inserting your USIM/SIM card and battery, you can now power on and
start using your device.
Turn your device on and off
To turn on the power
Press and hold the POWER button for a few seconds.
When you turn on your device for the first time, a Quick Start Wizard
will guide you through the calibration process and the setup of regional
settings, date and time, and password. For more information about touch
screen calibration, see “Calibrate the device”.
To turn off the power
Press and hold the POWER button for a few seconds.
A message will then be displayed, prompting you whether or not to turn off
the device completely.
Auto configure the data connection settings
The first time you power on your device, you will see a notification message
from the Connection Setup on the Today screen.
The Connection Setup can automatically configure your device’s data
connections, such as GPRS, WAP, and MMS, for you so that you do not need
to enter the settings manually onto your device.
To install the battery
Install the battery by inserting
it with its exposed copper part
aligned with the protruding copper
conductor on the lower-right side
of the battery compartment.
Insert the bottom side of the
battery first, then gently push the
battery into place.
Copper conductor
To replace the back cover
1. Secure the top part of the back
cover by ‘locking’ it into the 
openings on the device.
2. Press the middle portion of the
back cover.
3. Press the bottom part of the
back cover to lock it into place.
You should hear a click.
2
3
To install the microSD™ card
1. Pry open the rubber cover at the
bottom-left side of the device.
2. Insert the microSD card with the
gold contacts facing up.
3. Close the rubber cover.
Tip Press the microSD card to pop it
out of the slot.