HP KPEC992M - Manual (Page 15)

Regulatory and Safety Information
WARNING: Text set off in this manner indicates that failure to follow directions could result in
damage to equipment, loss of information, bodily harm, or loss of life.
WARNING: Please read the “Additional Safety Information” located later in this document
before installing and connecting your device to the electrical power system.
FCC Regulatory and Safety Information (USA Only)
Federal Communications Commission (FCC) Radio Frequency Interference Statement
WARNING: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet that is on a circuit different from the receiver.
•
Consult the dealer or an experienced radio/TV technician for help.
The system RFI and Radiated Immunity tests were conducted with supported peripheral devices
and shielded cables, such as those you receive with your system. Changes or modifications not
expressly approved by the manufacturer could void the user’s authority to operate the
equipment. To comply with the limits for an FCC Class B computing device, always use shielded
signal cables and the power cord supplied with this unit.
WARNING: When using this device, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, and injury to persons, including the following:
•
Do not use this product near water; for example, near a bathtub, wash bowl, kitchen sink,
or laundry tub, in a wet basement, or near a swimming pool.
•
Avoid using this product during an electrical storm. There may be a remote risk of electric
shock from lightning.
•
Do not use this product to report a gas leak in the vicinity of the leak.
•
Always disconnect the modem cable before opening the equipment enclosure or touching an
uninsulated modem cable, jack, or internal components.
•
If this product was not provided with a telephone line cord, use only No. 26 AWG or larger
telecommunication line cord in order to reduce the risk of fire.
•
Do not plug a modem or telephone cable into the Network Interface Card (NIC) receptacle.
SAVE THESE INSTRUCTIONS