Hunter Fan 43665 - Manual (Page 8)

8
INSTALLATION
Wall Mounting Plate Thermostat Cover
Wall Mounting Plate Thermostat Cover
What You Need
This thermostat includes two #8 slotted screws and two wall
anchors for mounting. To install your thermostat, you should
have the following tools and materials.
CAUTION: Do not remove any wiring from existing thermo-
stat before reading the instructions carefully. WIRES MUST
BE LABELED PRIOR TO REMOVAL.
■ IMPORTANT! Turn off the power to the furnace at the
main power panel or at the furnace.
■ Remove existing thermostat cover. See Figure . Some ther-
mostats will have screws or other locking devices that must
first be removed. Once wall mounting plate is exposed, look
for wires.
If wires are not visible, they may be connected to the back of the
wallplate. Again, look for screws, tabs, etc. Some models have
doors that open to expose wires and mounting screws. (See
Figure ).
Remove Old Thermostat
TYPICAL HOME THERMOSTATS
Figure 
■ Slotted Screwdriver(s) ■ Electric drill and /6" bit
■ Phillips Screwdriver
■ Two .5 V (AA) size alkaline batteries
■ Hammer