Factory reset, Figure 2-16, Factory reset switch – Honeywell HRXD9 User Manual
Page 30
Installation
30
Factory Reset
Figure 2-16
Factory Reset Switch
The DVR has a Factory Reset switch to the left of the USB port on the rear panel. This
switch will only be used on the rare occasions that you want to return all the settings to
the original factory settings.
Caution
When using the Factory Reset, you will lose any settings you have
saved.
To reset the unit, you will need a straightened paperclip:
1.
Turn the DVR off.
2.
Turn it on again.
3.
While the DVR is initializing, the front panel LEDs will blink. When any of the
Camera 1 to 8 LEDs blink, poke the straightened paperclip in the unlabeled hole
to the left of the USB port.
4.
Hold the switch until all the LEDs on the front panel are lit.
Note
When the DVR successfully resets to factory defaults, all the
LEDs on the front panel will flash five times.
5.
Release the reset switch. All of the DVR’s settings are now at the original settings it
had when it left the factory.