Havis-Shields Kwik-Kit KK-100-06 - Manual (Page 14)

KK-XXX-06_INST_8-07 14
Item #6
to #5
Item #6 Item #6
Place Rear Bulkhead
Doorframe into vehicle
Position between Driver and
Passenger-side Bench/Wall
assemblies
Loosely attach Doorframe to Center
divider using #10 x 3/8” flat head
machine screws and nylock nuts
Item #6 to #2
Place the 3
rd
Compartment
Doorframe assembly.
Item #11
Note: It is recommended to put
edge molding on the OEM door
opening on the passenger side to
avoid damaging the Kwik kit
door.
Loosely bolt Rear Bulkhead
Doorframe (at the door hinge) to
Bench/Wall assemblies using ¼”
x ¾” carriage bolts, washers and
serrated nuts
Press doorframe to align with holes in
Passenger-side Bench/Wall
assembly.
Item #11
to #9
Align 3
rd
Compartment Doorframe to
3
rd
Compartment Ceiling and loosely
attach ¼” x ¾” hex head bolts, washers
and serrated nuts.
Item #12 to #11