HP T3304 - Manual (Page 27)

Printhead
Latch Hinge
Plate
installing the ribbon
19 Operator’s Guide
7
Raise the J-hook upward, and place the
end of the ribbon over the take-up hub.
8
Slide the J-hook back into place, as
shown. While holding the ribbon take-up
hub, rotate the J-hook counterclockwise
to latch.
Turn the take-up hub until all the ribbon
slack is removed.
9
Raise the hinge plate, and lock the
printhead by rotating the printhead latch
clockwise.
10
Close the media supply door.
11
Press ON LINE/PAUSE to enable
printing.
J-Hook
Take-Up Hub
Ribbon