Where to go from here, Where to go from here -4 – HP 212M User Manual
Page 20
2-4
Configuring an IP Address on the Switch
Manually Configuring an IP Address
Configuring a
n
IP Address
on
the Switc
h
Where To Go From Here
The above procedure configures your switch with an IP address and subnet
mask. With the proper network connections, you can now manage the switch
from a network management station, or from a PC equipped with a web
browser, or through a Telnet session to the switch console.
■
To access the switch using a web browser, refer to chapter 3, “Using the
HP Web Browser Interface”.
■
To continue to use the switch console, refer to chapter 4, “Using the Switch
Console”.
■
To access the switch using a network management tool, refer to chapter
5, “Using HP TopTools to Monitor and Manage the Switch”.
■
Inbound Telnet access to the switch is enabled in the factory default
configuration.
•
To change the Telnet access parameter, refer to “Using the Switch
Console to Configure the Console/Serial Link” on page 6-21.
•
To use Telnet to access the switch console refer to “Starting and
Ending a Console Session” on page 4-2.
■
For problems or error indications, refer to chapter 8, “Troubleshooting”.
Sraswb.book : SIER_SW2.FM Page 4 Tuesday, June 30, 1998 12:20 PM