Horizon Fitness E401 - Manual (Page 5)

BEFORE
YOU
BEGIN

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
HORIZON
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y

INTRODUCTION
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
HORIZON WARRANTY
IMPORT
ANT
PRECAUTIONS
Open HARDWARE BAG FOR STEP 2.
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT
WASHERS (C).
Insert the TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.
Slide CONSOLE MAST BOOT down to seal the console mast hole.
DO NOT PINCH WIRES!
A
B
C
D
E
ASSEMBLY STEP 
CONSOLE MAST
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
MAIN FRAME
CONSOLE MAST BOOT
TOP FRONT COVER
TOP BACK COVER
CONSOLE WIRES
#0-5
"

NN
2UZ
 413*/(
8"4)&3
#

NN
2UZ
 '-"5
8"4)&3
$

NN
2UZ

HARDWARE BAG FOR STEP 2 CONTENTS :
ASSEMBLY STEP 2
CONSOLE MAST
LOWER HANDLEBAR
PRE-ATTACHED
BOLT & WASHER
UPPER HANDLEBAR
PRE-ATTACHED
SET SCREWS
NOTCH
TAB
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT &
WASHERS.
Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars
are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED
SET SCREWS.
Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
A
B
C
D
E401_Rev.1.5.indd 8-9 2/29/08 10:05:32 AM