Horizon Fitness E401 - Manual (Page 6)

BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
HORIZON
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
11
INTRODUCTION
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
HORIZON WARRANTY
IMPORT
ANT
PRECAUTIONS
ASSEMBLY STEP 4
PEDAL ARM TUBE
TEFLON WASHERS (E)
BOLT (G)
FLAT WASHER (F)
LOWER LINK ARM
LINK ARM BRACKET
SPACER (D)
PEDAL ARM
ASSEMBLY STEP 
Open HARDWARE BAG FOR STEP .
Slide SPACER (H) into LOWER LINK ARM.
Place TEFLON WASHERS (I) on either side of SPACER (H). While holding TEFLON WASHERS (I) slide LOWER
LINK ARM into bottom end of LOWER HANDLEBAR.
Insert BOLT (J) into LOWER HANDLEBAR and secure using NUT (K).
Repeat on other side.
A
B
C
D
E
GUIDE RAIL
TEFLON WASHERS (I)
LOWER HANDLEBAR
NUT (K)
BOLT (J)
LOWER LINK ARM
SPACER (H)
LOWER LINK ARM
SPACER
TEFLON WASHERS
LOWER
HANDLEBAR
NUT (K)
INSIDE DIAMETER:
8 mm
Qty: 2
BOLT (J)
60 mm
Qty: 2
SPACER (H)
44 mm
Qty: 2 TEFLON WASHER (I)
28.4 mm
Qty: 4
HARDWARE BAG FOR STEP  CONTENTS :
Open HARDWARE BAG FOR STEP 4.
Align the bracket on the LEFT LOWER LINK ARM with the tube on the LEFT PEDAL ARM.
Slide the SPACER (D) through the LINK ARM BRACKET and the PEDAL ARM so it can’t rotate.
Insert 2 TEFLON WASHERS (E) between the PEDAL ARM and the LINK ARM BRACKET.
Secure the joint with a FLAT WASHER (F) and BOLT (G).
Repeat on the other side.
A
B
C
D
E
F
BOLT (G)
15 mm
Qty: 2
TEFLON WASHER (E)
30 mm
Qty: 4 SPACER (D)
Qty: 2
FLAT WASHER (F)
35 mm
Qty: 2
HARDWARE BAG FOR STEP 4 CONTENTS :
E401_Rev.1.5.indd 10-11 2/29/08 10:05:37 AM