Hitachi DZ-HS500SW - Manual (Page 151)

English
151
Operating sound is
heard cyclically. This sound is heard because the disc is cyclically operated and
does not indicate a fault.
—
Some vibrations are felt
or slight sound is heard
from mechanism. These vibrations or sound are caused by HDD/disc drive: This
does not indicate a fault.
—
• No operation can be
performed because
the ACCESS/PC or
CARD ACCESS
indicator on this DVD
video camera/
recorder remains lit or
blinking.
• After disc or card is
inserted, it takes
some time until
recording is possible.
In the following cases, it will take more time than usual until
operation is possible:
• Immediately after a disc or card is reinserted.
• When a long time has elapsed since the DVD video camera/
recorder was turned off last.
• When the temperature is greatly different from the status of
previous recording.
• When disc with scratches, dirt or fingerprints is inserted.
• When disc is subject to severe vibrations.
• When the battery or DC power cord was disconnected instead
of following the correct procedure using power switch to turn
the DVD video camera/recorder off.
7, 37
No image in viewfinder. • Is LCD monitor open?
No image will appear in viewfinder unless the LCD monitor is
closed and securely locked to DVD video camera/recorder.
• Is the DVD video camera/recorder set to the sleep/restart
status?
Press the SLEEP/RESTART button to release the sleep/restart
status.
31, 42
No image appears on
the LCD screen or in
the viewfinder. • Is DVD video camera/recorder connected to PC using PC
connection cable?
Unplug the PC connection cable.
• Does DVD video camera/recorder stop at the end of the scene
to which wipe-out was set and played back?
Press the DISC NAVIGATION button.
• Is the DVD video camera/recorder set to the sleep/restart
status?
Press the SLEEP/RESTART button to release the sleep/restart
status.
42, 87, 123
Symptom Cause and Correction
Reference
page