haier Gas & Electric Dryer RDE/RDG 350AW - Manual (Page 25)

• Lint filter needs to be cleaned before or after each use for your unit to
operate at optimum efficiency. The filter can be removed by pulling on
the handle of the lint filter located inside the dryer door. Remove lint. The filter
may be washed or vacuumed. This will remove dust and particles trapped in
the filter. Lint built up in screen will restrict airflows, which causes longer drying
times. After cleaning, slide the filter back in place. Do not use your dryer
without the lint filter in position.
• Do not use any type of spray cleaner when cleaning the interior.
• Hazardous fumes or electric shock could occur. If dryer drum becomes stained,
clean the drum with a damp cloth. Remove any residue before drying next
load.
• Clean the cabinet with mild soap and water. Do not use harsh or abrasive
cleaners, as this could damage the dryer.
• Clean the duct and the vent on a regular basis to avoid clogging which could
affect the efficiency of the dryer.
24
Lint Filter
The following sounds are normal during the operation of the dryer.
• Tumbling sound: this is normal as the heavy wet clothes in the dryer are
continuously being tossed around.
• Air rushing noise: this happens as the dryer drum spins and the air is rushing
through the dryer drum.
Tips
• For best drying results, clean the lint filter before or after every use.
• Do not overload the dryer.
• Balance the dryer load evenly throughout the dryer for the best result.
• Drying time depends on many variables: load size, type of fabric and
moisture in it, heat and moisture in the room, electric voltage, length of the
exhaust duct, etc.
• To eliminate guessing and to conserve energy an auto-drying setting is
recommeded.
• Always follow the fabric care instructions supplied by the garment manufacturer.
NORMAL OPERATING SOUNDS
CARE AND CLEANING GUIDE
English