Postinstallation and postupgrade checklist – HP BA322 90087 User Manual
Page 126
Table 7-1 Postinstallation and Postupgrade Checklist
Section
Task
For a newly installed system disk, you can back up the disk. (At this
point, you could reinstall OpenVMS onto the disk instead.)
For a newly upgraded system disk, if it is not going to be a shadow set
member, back up the system disk as a safeguard before proceeding
with the next steps. If your newly upgraded system disk is going to
be a shadow set member, you can re-form it in a later step. As an
optional precaution, you can back up the system disk as well.
□
Register any licenses that were not registered during the installation;
for an upgrade, register any new licenses.
□
New installations only (optional): Set system parameters to enable
□
Alpha upgrades only: Tune BAP system parameters.
□
If you set system parameters to enable volume shadowing or removed
hardcoded BAP system parameters, run AUTOGEN and reboot.
□
If you want to form a shadow set for a system disk, you can do this
now or later. If you upgrade a disk in a volume shadowing
environment, re-form the shadow set.
□
New installations, some upgrades: Perform the following tasks that
generally apply to new installations only but could also apply after an
upgrade:
□
Create proxy files, if required.
□
Set up the queue manager and start the default batch and print
queues.
□
Configure a multihead system, if applicable.
□
Configure DECnet if it was installed. After an upgrade, perform
only if DECnet was added during the upgrade.
□
Configure TCP/IP Services for OpenVMS if it was installed. After
an upgrade, configure TCP/IP Services only if it was added during
the upgrade.
□
If you are using neither DECnet nor TCP/IP Services, install and
configure third-party networking software, if necessary.
Networking software is required to download patches and for
certain layered products.
□
Initialize or configure the following products, as needed:
□
Initialize CDSA.
□
Configure Availability Manager.
□
Configure Kerberos.
□
Configure SSL for OpenVMS.
□
On Integrity servers using services that depend on WBEM Services
for OpenVMS, configure WBEM Services for OpenVMS.
□
On Integrity servers using services that depend on WBEM
Providers, configure WBEM Providers for OpenVMS.
□
On Integrity servers that use Instant Capacity (iCAP) or Temporary
Instant Capacity (TiCAP), configure the iCAP software.
□
On Integrity servers that use HP SIM services, configure HP SIM.
□
126
After Installing or Upgrading the OpenVMS Operating System