HomeTech 8-Port Voice Module SAM-V8M - Manual (Page 3)

2. Module Installation
Mounting:
Align the mounting pins with the grid holes on the back of the enclosure. With the
mounting pin plungers in the “out” position, press the unit into the grid in the desired
location, secure by pushing the plungers in.
Terminate Incoming Service Lines:
Run twisted pair cable from the telephone company demarcation point to the 110 IDC
labeled “LINE IN” on the SAM-V8M.
110 IDC Termination Procedure
Strip 3 in. of outer jacket from the cable. Place wires into proper slots according to
selected configuration. Starting at the blue-position of the IDC, begin with the white
wire of each pair as you progress to the orange-position on the IDC as shown
below. Press wires into slots with punch tool. Trim excess wire with diagonal
cutter.
Brown
White/Brown
Green
White/Green
Orange
White/Orange
Blue
White/Blue
NOTE: one pair of wires corresponds to
each line from the phone company. (Line
1=blue, Line 2=orange, Line 3=green,
Line 4=brown).