HomeTech 8-Port Voice Module SAM-V8M - Manual (Page 4)

Terminate Premise Wiring:
Direct Distribution
Run twisted pair cable from the telephone jacks throughout the premise to the
numbered distribution jacks. Terminate modular 8 position plugs to the horizontal
cables using the 568A wire standard.
Patch Panel Distribution
Run twisted pair cable from the telephone jacks throughout the premise to the 110
IDCs of a SAM-D8 patch panel using the termination procedure above. Connect
the numbered distribution ports of the SAM-V8M to the desired ports of the
SAM-D8 patch panel with 8 conductor patch cords.
Note: The 3” jumper cord must be plugged into the “OUT” & “TEST” ports to provide service to
premise wiring.
Alarm Interface Connection:
The SAM-V8M features a security interface port which may be connected to a security
system; in an emergency situation, the security system can seize telephone service on
LINE 1 when the alarm is activated. Connect 8 conductor cord from alarm dialer to the
“Security RJ31” port on the SAM-V8M.