Hitachi CP-X267 - Manual (Page 31)

3
3 . Using the Live Mode
3.3 Quick connection to the network (continued)
3 .3 .3 Connecting to the network
There are some options to connect to the
network.
• Enter PassCode
• Configure Manually
• Select From List
Select From List
Before selecting this item, your PC and the projectors need to be connected to the
same network.
If the connection is already established, select [Select From List].
From the list of the projectors connected to the network, select which projector
you would like to send your images. Proceed to the 3.6 Confirm the connection
to your destination. (50)
Enter PassCode
If you want to use the Passcode for network connection, select [Enter PassCode]
and click [NEXT].
The Passcode is given by the projector on screen. And you simply input the
Passcode to the “Live Viewer 3” to connect the network.
Proceed to the 3.4 Passcode connection. (32)
Configure Manually
Select [Configure Manually] and click [NEXT].
Then, there are 3 options on the manual connection method.
Select one of them to meet your requirement.
• Profile Proceed to the 3.5.1 Profile connection (41)
You just select one of the stored profile data to connect the network.
• History Proceed to the item 3.5.2 History connection (42)
Once connecting to the network, the “Live Viewer 3” stores the history.
If you need the same connection again, select [History].
Then, all you need to do is to select one of the history data from the list.
• Configure Network Settings Manually Proceed to the item 3.5.3
Configuring manually (43)
If you need to make the setting manually, select [Configure Network
Settings Manually].