Husqvarna HUV 5420 DXR - Manual (Page 18)

Controls and Indicators
227
Figure 9 Turn Signal and Horn Controls
ELECTRIC BED LIFT
The electric bed lift switch (13) is located on the instrument panel to the left of the key switch (Figure 7). To lift the
bed, pull up and hold the toggle switch in the upper position. Release switch to stop lifting operation. To close the
bed, press down and hold switch in the lower position. The bed lift will make a loud clicking sound to signal the
bed is in the rest position.
HAZARD LIGHTS
The hazard light switch (2) is located behind the turn signal handle (Figure 9). To activate the hazard lights, make sure
that the turn signal handle is in the center (off) position, then pull the switch marked “HAZARD” until it is locked in place.
To deactivate the hazard lights, move the turn signal handle in either direction and return it to the center position.
HIGH-TEMPERATURE WARNING LIGHT
The high-temperature warning light (10) is located on the instrument panel to the left of the steering column, next
to the low oil warning light (9) (Figure 7). The diesel engine is liquid-cooled; if the engine coolant has exceeded its
normal safe operating temperature, the warning light will illuminate. If the warning light lights up, stop the vehicle and
allow it to idle for approximately five minutes before stopping the engine. Contact a Husqvarna dealer/distributor or a
trained technician. See following WARNING.
WARNING
• Allow the engine to cool before servicing the engine coolant system. Engine coolant can cause
severe burns.
Page 16 HUV 5420 DX
R
Homologated Diesel Vehicle for Europe Owner’s Manual