Husqvarna HUV 5420 DXR - Manual (Page 40)

Gearcase Lubrication
GEARCASE LUBRICATION
NOTE: Dispose of used oil according to the environmental laws and regulations for your area.
LUBRICATION LEVEL CHECK FOR FRONT DIFFERENTIAL, TRANSMISSION, AND REAR
DIFFERENTIAL
Each gearcase component is equipped with two oil port plugs (1 and 2) (Figure 23, Figure 24, and Figure 25). When
the vehicle is on a level surface, use the level indicator hole (upper plug) (1) as a lubricant level indicator. Lubricant
level should be even with the bottom of level indicator hole (1).
LUBRICATION CHANGE FOR FRONT DIFFERENTIAL, TRANSMISSION, AND REAR
DIFFERENTIAL
Use the lower plug (2) for drainage (Figure 23, Figure 24, or Figure 25). Remove both plugs to allow the lubricant to
drain faster. See preceding NOTE.
Front differential:
Clean and install the drain plug (2) and washer before filling the front differential with new lubricant (Figure 23). Tighten
the drain plug to 108 in-lb (12 N·m). Use a funnel when filling the front differential through the lubricant level indicator
hole (1). See Periodic Lubrication Schedule on page 32. Tighten the level indicator plug to 120 in-lb (14 N·m).
1
2
1
2
215
Figure 23 Front Differential Lubrication Level
216
Figure 24 Transmission Lubrication Level
Transmission:
Clean and install the drain plug (2) before filling the transmission with new lubricant (Figure 24). Tighten the drain
plug to 96 in-lb (11 N·m). Remove the fill plug from the top of the transmission case and use a funnel to fill the
transmission with lubricant. See Periodic Lubrication Schedule on page 32. Apply Loctite 567 to the threads of
the fill plug and tighten to 21 ft-lb (28 N·m).
Page 38 HUV 5420 DX
R
Homologated Diesel Vehicle for Europe Owner’s Manual