Husqvarna HUV 5420 DXR - Manual (Page 36)

Engine Oil
ENGINE OIL LEVEL CHECK
1. Remove the oil level dipstick from the oil filler tube and wipe oil from the dipstick (Figure 17). See following
CAUTION.
CAUTION
• Do not remove dipstick while engine is running.
2. Check oil level by fully inserting the dipstick into the tube and immediately removing it.
3. If the oil level is at or below the low level mark on the dipstick gauge, add oil to the engine until the level is
between low and full levels (safe level). See following CAUTION.
CAUTION
• Do not exceed recommended oil capacity. Doing so will decrease engine performance or result in
damage to the engine.
3
2
1
1. Full Level 2. Safe Level 3. Low Level
204
Figure 17 Engine Oil Level Check
ENGINE OIL AND FILTER CHANGE
Engine oil and oil filter should be changed after the first 50 hours of operation (diesel). After that, they should be
changed every 100 hours of operation or annually, whichever comes first.
Engine Oil Draining
1. Turn the key switch to the OFF position and remove the key. Place the Forward/Reverse handle in the NEUTRAL
position. Chock the front wheels.
2. Disconnect battery. See Disconnecting the Battery – Diesel Vehicles on page 9.
3. Remove the oil filler cap to allow the oil to drain properly.
4. Position a pan designed for oil changes under the drain plug (Figure 18).
Page 34 HUV 5420 DX
R
Homologated Diesel Vehicle for Europe Owner’s Manual