Data editing, Prefix/suffix overview, To add a prefix or suffix – Honeywell 2020 User Manual
Page 77: Chapter 4 - data editing, Prefix/suffix overview -1, To add a prefix or suffix: -1
4 - 1
4
Data Editing
Prefix/Suffix Overview
When a barcode is scanned, additional information is sent to the host computer
along with the barcode data. This group of barcode data and additional,
user-defined data is called a “message string.” The selections in this section
are used to build the user-defined data into the message string.
Prefix and Suffix characters are data characters that can be sent before and
after scanned data. You can specify if they should be sent with all symbologies,
or only with specific symbologies. The following illustration shows the break-
down of a message string:
Points to Keep In Mind
•
It is not necessary to build a message string. The selections in this chapter
are only used if you wish to alter the default settings.
Default prefix = None.
Default suffix = None.
•
A prefix or suffix may be added or cleared from one symbology or all
symbologies.
•
You can add any prefix or suffix from the
ASCII Conversion Chart (Code Page
on page A-2, plus Code I.D. and AIM I.D.
•
You can string together several entries for several symbologies at one time.
•
Enter prefixes and suffixes in the order in which you want them to appear on
the output.
•
When setting up for specific symbologies (as opposed to all symbologies), the
specific symbology ID value counts as an added prefix or suffix character.
To Add a Prefix or Suffix:
Step 1. Scan the Add Prefix or Add Suffix symbol (
).
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in
) for the symbology to which you want to apply the prefix
or suffix. For example, for Code 128, Code ID is “j” and Hex ID is “6A”.
Step 3. Scan the 2 hex digits from the
cover of this manual or scan 9, 9 for all symbologies.
Prefix
Scanned Data
Suffix
1-11
alpha numeric &
control characters
variable length
1-11
alpha numeric &
control characters