Horizon Fitness ELLIPTICAL EX-76 - Manual (Page 5)

BEFORE
YOU
BEGIN

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
TOP CAP
CONSOLE MAST BOOT
CONSOLE MAST
MAIN FRAME CONSOLE WIRE
FLAT WASHER (D)
SPRING WASHER (C)
BOLT (B)
ARC WASHER (E)
ASSEMBLY STEP 2
A) Open HARDWARE BAG FOR STEP 2.
B) Slide the CONSOLE MAST BOOT followed by the TOP CAP over the CONSOLE MAST.
C) Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
D) Attach the sides of the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (B), 4 SPRING WASHERS (C) and 4
FLAT WASHERS (D).
E) Attach the front of the CONSOLE MAST to the MAIN FRAME using 2 BOLTS (B), 2 SPRING WASHERS (C) and 2
ARC WASHERS (E).
F) Slide TOP CAP and CONSOLE MAST BOOT down to seal the console mast hole.
BOLT (B)
15 mm
Qty: 6 SPRING WASHER (C)
15.4 mm
Qty: 6 FLAT WASHER (D)
20 mm
Qty: 4 ARC WASHER (E)
17 mm
Qty: 2
HARDWARE BAG FOR STEP 2 CONTENTS :
TOP CAP
CONSOLE MAST BOOT
CONSOLE MAST
MAIN FRAME CONSOLE WIRE
FLAT WASHER (D)
SPRING WASHER (C)
BOLT (B)
ARC WASHER (E)
ASSEMBLY STEP 1
A) Open HARDWARE BAG FOR STEP 1.
B) Attach the FRONT STABILIZER BAR to the the MAIN FRAME using 2 BOLTS (A).
BOLT (A)
20 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
FRONT STABILIZER BAR
BOLT (A)
MAIN FRAME
EX-76_Rev.1.4.indd 8-9 6/22/07 9:05:09 AM