Humminbird PIRANHAMAX 190CPT - Manual (Page 10)

3.
Assembling the Control Head to the Base and Handle
In this procedure you will install the control head onto the base assembly.
1. Insert the thumbknob bolt through the pivot knuckle on the control head.
2. Align the pivot knuckle with the mount arms and slide into place, twisting
slightly if necessary, until the unit is firmly seated.
3. Rotate the control head to the desired angle and hand tighten the
thumbknob bolt.
4. Thread the gimbal knob onto the pivot bolt and tighten.
Pivot
Knuckle
Gimbal Knob
Thumbknob
Bolt
Assembling the Control Head to the Base and Handle
Gimbal Knob
Rear View Front View
4