Humminbird PIRANHAMAX 190CPT - Manual (Page 16)

7.
Assembling the Transducer Mounting Bracket
In this procedure you will assemble the portable transducer mounting bracket.
1. Line up the two ratchet pieces at position 1 so that the beads are aligned
with the rib on the transducer. See illustrations.
2. Assemble the other transducer parts as shown (see the illustration
Assembling the Portable Bracket below). Hand tighten only!
NOTE: If you are unable to ratchet the transducer so that it rests below the water and
points straight down, you can disassemble it and align the beads with a different
number until you reach a position that allows the proper alignment.
Assembling the Portable Bracket
Suction Cup
Portable Transducer
Assembly
Phillips Head
Screw
Washer
Wing Nut
Bolt
Ratchet
Transducer Knuckle Positions
Knuckle
Ratchets Placed in Position 1
Rib at
position 1
Beads
Ratchet
10