Humminbird PIRANHAMAX 190CPT - Manual (Page 11)

4.
Routing the Cables in the Base
In this procedure, you will route the
power and transducer jumper cables on
the underside of the base, and attach the
tie-down straps that will be used to
secure the battery to the base in a later
procedure.
1. Turn the base upside down, then
thread the two included hook
and loop battery tie-down straps
from the bottom of the base up
through each side of the battery
well, using the strap holes (see
the illustration Attaching the
Battery Tie-Down Straps).
2. Route the power cable from the mount DOWN through the center hole
of the base. Route the transducer jump cable UP through the base
and mount.
Pulling the Cables Through the Base
Attaching the Battery Tie-Down Straps
Battery
tie-down straps
5