HP CM3530 - Manual (Page 48)

Menu item Sub-menu item Sub-menu item Values and Description
Manual : Use the Manual Settings menu to configure
TCP/IPv4 parameters.
Default IP Specify the IP address to default to when the print
server is unable to obtain an IP address from the
network during a forced TCP/IP reconfiguration (for
example, when manually configured to use BootP or
DHCP).
Auto IP : A link-local IP address 169.254.x.x is set.
Legacy : The address 192.0.0.192 is set, consistent
with older HP Jetdirect products.
DHCP Release This menu appears if Config Method was set to
DHCP and a DHCP lease for the print server exists.
No (default): The current DHCP lease is saved.
Yes : The current DHCP lease and the leased IP
address are released.
DHCP Renew This menu appears if Config Method was set to
DHCP and a DHCP lease for the print server exists.
No (default): The print server does not request to renew
the DHCP lease.
Yes : The print server requests to renew the current
DHCP lease.
Manual Settings (Available only if Config Method is set to Manual )
Configure parameters directly from the printer control
panel:
IP Address : The unique IP address of the printer
(n.n.n.n), where n is a value from 0 to 255.
Subnet Mask : The subnet mask for the printer
(m.m.m.m), where m is a value from 0 to 255.
Syslog Server : The IP address of the syslog server
used to receive and log syslog messages.
Default Gateway : The IP address of the gateway or
router used for communications with other networks.
Idle Timeout : The time period, in seconds, after which
an idle TCP print data connection is closed (default is
270 seconds, 0 disables the timeout).
Primary DNS Specify the IP address (n.n.n.n) of a Primary DNS
Server.
Secondary DNS Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
IPV6 Settings Enable Use this item to enable or disable IPv6 operation on the
print server.
Off : IPv6 is disabled.
On (default): IPv6 is enabled.
Table 2-11 Jetdirect menus (continued)
34 Chapter 2 Control panel ENWW