Horizon Fitness ROJO T5 - Manual (Page 4)

ASSEMBLY STEP 4 ASSEMBLY STEP 3
RIGHT HANDLEBAR
CONSOLE MASTS
BOLTS (A)
FLAT WASHERS (B)
ARC WASHERS (D)
SPRING WASHERS (C)
SPRING WASHERS (C)
BOLTS (A)
CONSOLE CABLE
A
B
C
D
BOLT (A)
20 mm
Qty: 6
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 6
ARC WASHER (D)
8 mm
Qty: 2
CABLE HOLE
CONSOLE CABLE
RIGHT CONSOLE MAST
RIGHT HANDLEBAR
PULSE CABLE
POWER CABLE
CONSOLE CABLE
CONSOLE
CUP HOLDER
SCREW (F)
SCREWS (E)
A
B
SCREW (E)
15 mm
Qty: 4
SCREW (F)
30 mm
Qty: 2
HARDWARE BAG 3 CONTENTS: HARDWARE BAG 4 CONTENTS:
NOTE: Carefully align holes when
assembling handlebars to console
mast, making sure to not press down
on handlebars.
NOTE: Do not completely tighten any
screws or bolts until step 6 is
complete!
NOTE: Assembly of cup holders may be easier if console is flipped upside down before inserting screws. Be careful
not to overtighten screws.
Open HARDWARE BAG 4.
Attache CUP HOLDERS to CONSOLE by inserting 4 SCREWS (E) and 2 SCREWS (F).
Open HARDWARE BAG 3.
With the running deck in the lowered
position, place the RIGHT HANDLE-
BAR on top of the RIGHT CONSOLE
MAST. Carefully route the CONSOLE
CABLE through the bottom of the
handlebar and out the CABLE HOLE
as shown in second drawing below.
The PULSE CABLE and POWER
CABLE should be pulled out of the
hole as well.
NOTE: Do not pinch the CONSOLE
CABLE when placing right handlebar
on top of the RIGHT CONSOLE MAST.
To assemble the RIGHT HANDLEBAR
to the RIGHT CONSOLE MAST, insert
2 BOLTS (A), 2 SPRING WASHERS
(C) and 2 FLAT WASHERS (B) in the
inside of the mast and 1 BOLT (A), 1
SPRING WASHER (C) and 1 ARC
WASHER (D) in the rear of the mast
as shown.
Repeat on other side.
NOTE: Only the pulse cable will need
to be routed through the cable hole
on the left handlebar.
5 6
2/15/09 10:22 AM