Horizon Fitness ROJO T5 - Manual (Page 5)

YOU’RE FINISHED!
CIRCUIT BREAKER
ON/OFF SWITCH
ASSEMBLY STEP 5
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (G)
CONSOLE
HANDLEBAR BRACKET
RIGHT SIDE:
CONNECT CONSOLE
CABLES, PULSE CABLES
AND POWER CABLES
LEFT SIDE:
CONNECT PULSE
CABLES ONLY
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 4
BOLT (G)
16 mm
Qty: 4
A
B
C
D
E
F
G
ASSEMBLY STEP 6
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (A)
ARC WASHER (D)
SPRING WASHER (C)
BOLT (A)
SUPPORT BAR
MAIN FRAME
HANDLEBAR
Repeat on the other side.
A
B
C
D
E
F
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 6
ARC WASHER (D)
8 mm
Qty: 2
BOLT (A)
20 mm
Qty: 6
HARDWARE BAG 5 CONTENTS: HARDWARE BAG 6 CONTENTS:
NOTE: Do not completely tighten any bolts
until step 6 is complete!
Open HARDWARE BAG 5.
Place CONSOLE onto HANDLEBAR BRACKETS
as shown.
NOTE: Do not pinch CONSOLE CABLE when
placing the console onto the handlebar brack-
ets.
Insert 2 BOLTS (G), 2 SPRING WASHERS (C)
and 2 FLAT WASHERS (B) through the bottom
of the HANDLEBAR BRACKET to secure the
console to the HANDLEBAR BRACKET.
Repeat on other side.
Reach inside the right underside of the
console to pull out the CONSOLECABLE,
PULSECABLE and POWER CABLE. Attach to
the matching cables that are hanging out of
the cable hole in the handlebar.
Repeat on left side to attach PULSECABLE.
Thread attached cables back through the
cable holes when finished.
Open HARDWARE BAG 6.
With the running deck in the lowered
position, place the SUPPORT BAR
between the HANDLEBAR and the
MAIN FRAME.
To attach the SUPPORT BAR, insert
1 BOLT (A), 1 SPRING WASHER (C)
and 1 ARC WASHER (D) in the top of
the SUPPORT BAR and 2 BOLTS(A),
2 SPRING WASHERS (C) and 2 FLAT
WASHERS (B) in the bottom of the
SUPPORTBAR as shown.
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a
beep and the console will light up.
Before the first use, lubricate the
treadmill deck by following the
instructions in the Maintenance
section.
7 8
2/15/09 10:28 AM