Philips QC 5099 - Manual (Page 10)

4 Clean the cutting unit with the brush supplied (Fig. 9).
5 Also clean the inside of the appliance with the brush supplied.
6 Place the lug of the cutting unit into the slot and push the unit back
onto the appliance (‘click’) (Fig. 8).
This appliance does not need any lubrication.
Replacement
A worn or damaged cutting unit should only be replaced with an original
Philips cutting unit.
Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 7).
Place the lug of the new cutting unit into the slot and push the unit
back onto the appliance (‘click’) (Fig. 8).
Environment
Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. (Fig. 10)
The built-in rechargeable battery contains substances that may
pollute the environment. Always remove the battery before you
discard and hand in the appliance at an official collection point.
Dispose of the battery at an official collection point for batteries. If
you have trouble removing the battery, you can also take the
appliance to a Philips service centre. The staff of this centre will
remove the battery for you and will dispose of it in an
environmentally safe way.
Disposal of the battery
Only remove the battery if it is completely empty.
1 Disconnect the appliance from the mains and let the appliance run
until the motor stops.
 Open and remove the cutting unit (see chapter ‘Cleaning’).
-
-
-
-
English 10