Philips QC 5099 - Manual (Page 11)

 Undo the screws and remove the metal clip with a
screwdriver (Fig. 11).
4 Remove the top part by pulling it off the appliance (Fig. 1).
5 Turn the hair length adjustment ring until the comb holder is in its
highest position (Fig. 1).
6 Then use some force to turn the adjustment ring still further until
the comb holder comes loose from the appliance (Fig. 14).
7 Separate the two housing parts with a screwdriver (Fig. 15).
8 Pull out the printed circuit board (Fig. 16).
9 Insert a screwdriver into the small slot in the printed circuit board.
Push the screwdriver down until part of the printed circuit board
breaks off (Fig. 17).
10 Open the plastic battery holder and take out the rechargeable
battery (Fig. 18).
Do not connect the appliance to the mains again after it has been
opened.
guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you find its phone number in the worldwide
guarantee leaflet). If there is no Customer Care Centre in your country,
go to your local Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.
English 11